Set up your Orbi as an Access Point

1. Connect Orbi to the AT&T Modem using an ethernet cable (included).
2. From a browser, go to orbilogin.com and sign in.
3. Enter the router admin user name and password.

• • The username is admin.
  • The default password is password.

1. Select ADVANCED > Advanced Setup > Router/AP Mode.
2. From the Router/AP Mode, select AP Mode radio button.
3. Select the IP address setting. There are two options, the 1st is recommended:

• • Get dynamically from existing router. The other router on the network assigns an IP address to this router while this router is in AP mode. (Recommended)
  • Enable fixed IP settings on this device (not recommended). Use this setting if you want to manually assign a specific IP address to this router while it is in AP mode. Using this option effectively requires advanced network experience.

1. Select Apply.

Once your Orbi is connected: Turn off Wi-Fi On the AT&T Modem

Disabling the Wi-Fi will prevent Wi-Fi conflicts between the Orbi and AT&T modem.

1. Sign into your modem (You’ll find the access code on the modem)
2. Go to Settings, then LAN, and select the Wi-Fi Tab
3. Select Disable on the Wi-Fi Interface
4. Scroll down and select Save (you may need to reenter the Access Code)